Slider design SB 315

Nail design slider TM 586 The DreamNails TW series of sliders are white opaque images on a transparent base. One set of sliders contains at least 12 images (main + spare). Stickers are made on a transparent film photonailart. Drawings on the stickers of the TW series can be of a wide variety of subjects, from monograms and flowers, ending with a marine theme, hearts, butterflies and abstract images. Technology for applying Dreamnails sliders: Note: for images on a white background, foil and white drawings, any color of the gel coating, up to dark, can be used as a substrate. Translucent drawings require a light background, ideally white. Important: in cold water, the film may tear! Please note: to protect the slider from mechanical damage, leave small gaps of 1-2 mm on all sides. Before you start creating a slider design, do a manicure and prepare your nails for gel polish (walk the buff over the nail plate, degrease it and apply a primer).Apply a layer of base coat for gel polish and dry in a UV or LED lamp for up to two minutes.Coat your nails with a thin coat of your chosen base color. If the color of the gel polish is not dense enough, reapply. Fix alternately each layer of color coating in the lamp for 2 minutes. The sticky layer does not need to be removed.Cut out the selected sticker so that it fits the width of the nail plate and its shape.Dip the cut out fragment of the pattern in warm water (30-40 ° C) for 15-20 minutes or place it on a damp sponge. As a result, the film with the image should become movable. If necessary, blot excess liquid with a tissue.Separate the film with the image from the paper base by gently sliding it with a slight movement of the hand.Place the slider piece on the nail, starting at the cuticle and gradually smoothing out towards the free edge of the nail.Use a nail file to remove excess film. Hold the nail file at a 45° angle to the free edge of the nail. To eliminate residual moisture, dry your nails in a UV (LED) lamp.Coat the slider design with a layer of base gel coat and cure in a lamp.On top of the base, apply a gel polish top coat in two layers, curing each in a UV (LED) lamp.After drying, remove the residual tacky layer of the top coat with a clinser and a lint-free cloth.